Tuesday, May 23, 2017

Stamped Minis

Hi Everyone,

Wow, I was not expecting quite the tremendous response to the raw bar minis yesterday. I ran out well before I was able to respond to the nearly 100 emails I received. So I am sorry I was not able to hook everyone up who wanted one.

You know, I never know how many to make on any given project. Sometimes I have made a large batch of tools and I end up with dozens left over. I still have a dozen or two of the titanium Mini P15 Prybabies for instance, also a couple of steel Mini P15s, and this is almost two years after they were released!

So this year I am making smaller batches on some of these tools. And that means some tools may be harder to score...don't know of any other solution and I am not about to set up lists or anything like that (I tried that years ago) because that will make me totally crazy and I will have to give this all up and retire. Haha, yeah right, ok maybe not retire, but lists are waaaay too inefficient for one guy to handle...And so, here we are. :) Anyhow,  I do my best and I am IMMENSELY grateful for you patience and continued support!

So, today I have another small batch of the Mini Prybabies done. This is the end of them btw...these are surface ground so they are slightly thinner than the raw bar ones from yesterday. They are all stamped! They also have a similar light bead blast finish so I recommend oiling them if you wish to prevent rust from forming on the CPM 3v tool steel.

No lefties remain....sorry about that. I hooked every one up yesterday as best as I could.

Stamped Mini P17s will run $75 plus shipping and it is of course a one per customer limit on them. Hopefully a few folks who couldn't catch the two minute sale yesterday and can score one of these...



Sold out, thank you everyone!


7 comments:

Unknown said...

Where do I email to try and get a steel P15? =D

Would HATE for you to have leftovers ;)

Easy Wind said...

BEE!

John said...

two for not :-( lol never going out for lunch again!

Unknown said...

Hi peter how can I get a ti mini p15?

Leslie TAN said...

Miss it again, how can i know which tool will release soon? Is any newsletter list>?

Mark said...

May I get one of your leftover titanium Mini 15 Prybabies? I haven't been able to buy anything in years.

Unknown said...

Im after one as well