Shutterbugs!

Hi Folks,

Well, that magic day has finally arrived...these little tools have been on the drawing board for 3-4 years and this winter I finally got around to actually starting the project. There have been so many delays that it's been beyond ridiculous but at long last I have them ready to go and I must say it is a big relief. I sure hope the next batch goes a little easier.

Anyhow, many have been asking the question, what exactly is a Shutterbug? The Shutterbugs are the third in the Superbug series, basically a mutation of the Original Superbug and the Weevil. I wanted to make a tool that was specifically geared towards photographers, and as many of you know, I am a very serious photography enthusiast and camera collector.

So what features might a photographer's tool have on it and how could I also make it such that it would also appeal to a broad group of non photographers?

We'll start with the "nose"....

Old school FILM cameras, which is what I mostly collect and use, often have button batteries or, in the case of the great point and shoot cameras of the 1990's, a lithium battery. These cameras usually have a little screw on battery cover with a coin slot on it. The Shutterbugs have a rounded nose bevel that will fit coin slot grooves and also double as a tool for tripod bushings which often feature a similar groove. It can also be used for all sorts of general prying and scraping tasks as well.

Next is the "eye" of the tool. Here I have reamed the opening to fit PC flash cord ends. This tool can help the pros who use flash cables to repair an end that has become out of round which appears to be a common issue with these cables.

I include a phillips bit and 1/4" hex opening for the captive bit portion of the tool. For those pros and totally gonzo gearheads such as myself who use RRS ballheads and brackets, I do have a few hex bits on hand that fit the screws...while supplies last. You will have to email me and ask for them though as I only have a couple dozen and they are quite pricey...don't know what RRS is? Don't go there, your wallet and your wife both send their thanks! :)

(Note: Darn it! I just double checked the hex bits which only just arrived yesterday and I have the wrong size. Will have to reorder and send the bit separately later this week to those who have requested for RRS. Sorry about that...thanks.) 

To complete the tool and round out the universal appeal, the "butt" end features a flathead screwdriver/prytool and the lanyard opening doubles as an O2 wrench. And of course every photographer and non photographer alike needs a handy cap lifter. ;)

The Shutterbugs weigh 30 grams with the bit. They are 3 inches long and .70" wide, .160" thick and are made of CPM 3v Steel at 58 Rockwell. Concerned about your 3v Steel tools developing patina, ie. rust? Give them a periodic wipe with WD-40 or any kind of oil. This is a pure tool steel that is highly wear resistant and incredibly tough but to achieve that kind of performance it must sacrifice stainless qualities. Also, the O-rings will leave a bit of residue when you roll them on so a little wipe down beforehand will optimize appearance. I did not apply any oil yet as I did not want to stain the insert cards.

There are no variations in this batch. No stamps or special grinds.

The Shutterbugs will be $70 each plus shipping and it is a one per customer sale please as the batch is not very large. I have a second batch that I will be making in titanium later this summer but they will be flat, so an ultralight thin version is in the works.

Thanks for stopping by today and happy clicking this summer!

Shutterbugs are sold out for now, thank you so much!